This is support designed for a gopro session 5.

Actually, i'm still designing the different parts and different type of mount, but they will come soon !

There will be different type such as the one you can actually find where i merged the top plate and a 25° mount, soon a 20° & 30°, also a base to screw on the top plate with the case for the gopro where you could adjust the tilt.

⚠️The top plate is 3mm thick, if you find that to be to much, just lower the model of the neutral position of the orthonormed system !

D12 230 direct drive biqu custom

Doesn't Matter

Yes

0,2mm

100%

Personnally i use the "Tree" type support on Cura and the "Normal" type on Prusa Slicer.

--> I used a layer height of 0,18mm that makes a better surface print /quality but takes a bit more time at printing.
--> x2 Top surface skin layer
--> x3 to x4 wall line count
--> Print at the speed around 30mm/s & 40mm/s for the TPU, and 60mm/s with the PLA.