A tray with 20mm x 20mm stand-off holes for stacking a small receiver on or in an FC/ESC/VTX stack

I created this so i could re-locate the receiver on my iFlight Nazgul Evoque v2 while changing it from the original FrSky receiver and antenna setup to an ELRS R1.

Pretty much any small receiver including the original XM+ I removed should fit in it

I didn't like how it was just slid in the back and had it eject out from a crash before.

I added a no-legs version but my intention was to make a small tray that sit over the stack screws so it can be positioned and held in place above the VTX with the main power whip running between them in the stock setup of the Evoque

I printed it in TPU positioned upside down with Grid supports

All test prints were done with PLA which would work as well, but i wanted cushion and anti-rattle properties of TPU since I am not screwing it down onto the stack.

The holes are full pass through for M2 size in the event you need to secure it more.

• Printer: Prusa CoreOne
• Filament: Overture TPU
• Infill: Default (15%)
• Supports: Yes (Grid)
• Orientation: Top Face