This is a 3 parts assembly canopy for the DAYA 680 drone.
The canopy's center section has a groove at the bottom for attachment to the DAYA's top surface.
The rear section has a half circle opening to allow a GPS antenna on the drone's top surface.
Front and rear sections slide onto the center one.

Creality

Ender 3

No

Yes

20

Bed temp: 50
Tip temp: 210
Printing speed 50~70

I printed the rear at an upside down position (narrow top towards the plate) to allow minimum support.
I also raised it 2mm above the plate so that the support be easily detached after printing.

If you find my design useful and decide to use it, a small contribution be appreciated.

Enjoy and have a great build!