Summary

A guitar stand I made up for my daughter's full-sized acoustic guitar. Most parts print fine at 5% infill and 1.2mm walls for some strength. Recommend printing part#1 at 100% infill for extra piece of mind. Part#1 you print twice, no mirroring needed.

Made to put together using 1/2" diameter dowels of wood, carbon, etc. Put 1/2id rubber furniture feet on bottom parts to prevent sliding.

Part#3 has two different holes to choose what angle or to accommodate a different thickness guitar. I chose to print this in TPU.

Can use E6000 to hold parts if you want and very small screws on part#1.

Part#2 has the personalization debossing shown in the picture not present. Would be open to adding a different word if someone wants or as time allows.