Simple modular wall track to allow hanging items.

Print as many 6” sections as you need for the length you require. Print one end cap for each side. Clips should be minimum of two. Add additional clips to maintain support as you deem fit. Number of hooks printed based on your needs.

Track and Ends:
Printing the track ends only needs supports on the bed. Do not do supports everywhere to keep supports out of twist lock area. Print the sections with the single grove side on the bottom. Track sections twist lock together end to end. There are end caps to keep hooks from sliding off.

Wall Clips:
Print clips on their side. You can use supports everywhere to keep screw holes shaped correctly. Wall clips require flat head screws so clips fit track without issues. Can print as many wall clips as needed to where you feel secure. Wall clips snap on to track sections

Basic Hook:
Hooks should be printed on their side. Print as many hooks as required for your needs.

Prusa

I3 MK3S

Doesn't Matter

Yes

20

Supports are needed for only areas above bed when selecting.

Make sure there is not any filament blocking the internal lock swivel area. Supports not required everywhere, only areas above bed when printing track