Redesigned my MakerCoin a bit. Bigger in diameter, changed the edge pattern a little bit, and now has a super cool print-in-place rolling element! I'll still use the other one, of course, when I need to print a lot really fast, but I'll carry this one personally~. Also made a blank for you to edit; makercoin_new_b! ("b" for "blank". I know, I'm super clever, right?) Just upload it as a remix, please, and post pictures!

Note, the tolerances on this are tight, but not stupid tight, about 0.33mm between the parts. I did this knowing that not everybody has 0.05mm tolerances, especially when running at the speeds a lot of us print these coins. But keep in mind that if you do, this will just spin REALLY well.

Category: 3D Printing Tests