Project to build a motorized dice box with LED lighting. Controlled by Adafruit Trinket M0 and powered by a rechargeable battery.

Code for Adafruit Tinket M0: https://github.com/PhilFryTheCryoGuy/Dice_Box_Control

Non-3D printed parts used: -Adafruit Trinket M0 -Tower Pro SG51R Servo Motor -12mm LED Power Push Button Switch (3V) -Adafruit Flora RGB Smart Neopixels -Rocker 2Pin Toggle SPST Switch Snap -Adafruit JST-PH 2-Pin SMT Right Angle Breakout Board -ADAFRUIT INDUSTRIES 1578 Lithium Ion Polymer Battery - 3.7v 500mAh -2"x1" perf board -10k Ohm Resistor -Lots of hook up wire and Dupont connectors

Print Settings

Printer Brand:

Up

Printer:

**Rafts:**

Yes

Supports:

**Resolution:**

200

Infill:

**Filament:** Hatchbox Wood PLA Wood

Notes:

Post-Printing =============

Finished product. Space for miniature is large enough for it to lay down.

Open and close using the push button.

Empty Box

Close up of hinge showing connection of motor extender to lid. Lid held in place by by 1.75mm diameter pin(short piece of filament from a 3Doodler filament stick).

Backside of finished box showing pin used to hold lid together and rocker power switch

Bottom part with motor glued in place and extender arm glued onto motor arm.

Top lid.

Insert with LEDs glued into place.

Finished PCB board with dupont connection points and rechargable battery.

Rough circuit diagram

Category: Toy & Game Accessories