Aerobar End Caps
FreeRack
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2025-05-06 17:35:02
0
0
000설명
모델 소스
리뷰(0)
Designed to replace the rounded end caps of the Profile Design T2+ aero bar.
http://www.profile-design.com/profile-design/products/aerobars/aluminum-aerobars/t2-plus.html
My aero bars end caps got roughed up a bit from an accident so designed this as a replacement. I will post pictures soon.
*added the skp files so its easier for others to edit/modify.
design notes:
v5: I had to take a knife and cut down the top 2 rings a little bit to make it fit better. the tip was also very pointy to where it seemed like a hazard. so had to trim that down with a knife as well.
v6: shrank rings slightly, rounded the tip.added an internal structure to hold top ring on better.
v7: made it so it could print without supports, forgot to shrink rings though so they still may need cut down with a knife.
http://www.profile-design.com/profile-design/products/aerobars/aluminum-aerobars/t2-plus.html
My aero bars end caps got roughed up a bit from an accident so designed this as a replacement. I will post pictures soon.
*added the skp files so its easier for others to edit/modify.
design notes:
v5: I had to take a knife and cut down the top 2 rings a little bit to make it fit better. the tip was also very pointy to where it seemed like a hazard. so had to trim that down with a knife as well.
v6: shrank rings slightly, rounded the tip.added an internal structure to hold top ring on better.
v7: made it so it could print without supports, forgot to shrink rings though so they still may need cut down with a knife.
모델 소스
원본 링크: 자세히 보기
CC BY