Captured Bolt
katherine_rodriguez
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2024-03-21 13:52:49
0
0
000설명
모델 소스
리뷰(0)
My take of the old captured bolt. 1mm and 1_5mm refer to the gap between the bolt and nut. On my Prusa the 1mm was a bit hard to turn at 1st and the 1_5 is just a bit sloppy but acceptable.
Printed with the bolt standing up, the nut near the bottom. Use "Support on build plate only" (PrusaSlicer) or eq. I used .3mm layer height with PLA.
Enjoy!
모델 소스
원본 링크: 자세히 보기
CC BY-SA