Printing:

Print stick upside down and use support for the overhanging palm rest. Print with 2 wall perimeters and minimal infill due to it needing to be light as all the stress goes through the analogue stick.

Print the lock on the flat side.

The throttle is ment to be printed upside down as well but i have yet to print it so it may not be spaced correctly on the gamepad. Print with same settings as stick.

Setup:

Use some kind of fastener such as a rubber band or zip tie to attach the stick and clamp around the joystick.

THE THROTTLE IS A WIP AND HAS NOT BEEN TESTED! 

Feel free to test it out if you want and give some feedback. It should work, Im just uncertain whether it is to close to the main stick or not. 

I am planning on making some for xbox controllers as well but if you wanna remix it feel free.

Make sure to post a make