PRINT IN PETG!!!

Just a super-quick wedge I whipped up after figuring out my GTX 1060 for my 2nd and 3rd monitors was sagging enough for its fans to start scraping against the solder joints on my SoundBlasterX AE-5 Plus card and make a horrid noise. It's VERY long and skinny so it can pry them apart in a spot where the fans aren't going to hit the wedge either, with plenty of length to provide a nice adjustment range in case you're dealing with more than just two cards like I am.

Keep in mind layer height will affect how many ridges you get on one side of the wedge, so if you're looking for it to “catch” the solder joint, take this into consideration. Due to the heat of the case, NEVER print this in PLA.

Yes, it is literally just a wedge and took me all of about a minute to make in Fusion360. Nothing special nor impressive about the design, nor do I claim it to be either :)