Ambi Climate is an AI enabled smart controller designed to intuitively maintain aircon/heat pump settings based on your comfort level. The controller itself has a flat base designed to sit on a table or similar flat surface. In my case however, my heat pump sits on a wall that points down a long hallway. I had no flat surface to place the controller on so designed a bracket for it to be wall mounted instead. No supports needed when printing.

There are 2 x screw holes to fix to the wall, alternately you could use 3M strips or similar.

Refer: https://www.ambiclimate.com/

If you like it, click Like! If you make it, post your Make! If you have a problem with it, post a Comment and I will try and fix it!

Creality

Ender 5

Doesn't Matter

No

0.2

20%