This is another model I drew up in CAD to help complement your geocache hides! The last model I uploaded to printables included these small vital tubes; this print also requires those vital tubes as well.

For this model, as mentioned above, you will need some hardware, including the small vital tubes. See the links below for all the hardware required to hide this cache. For the assembly, there isn't much to it, but some glue may be required for gluing the cap into the designated hole. There are also two holes for 6x2mm magnets. No glue should be needed as the tolerances are low for a tight fit. 

Hardware Required:

• (x1) Vital Test Tube

• (x2) 6x2mm Magnets

Please feel free to leave the GC Code of your cache if you decide to hide a cache with this container! Also, please leave feedback. Thanks!