This is a specific implementation of the FT EMS (Electronic Mounting System) designed specifically for the Salad Fork 180 frame.

The Salad Fork is a fantastic sub-200mm Voron-based printer, but managing electronics in the base can get tight. This "SkeleFork" style EMS grid allows for a clean, modular way to mount your BTT Octopus, SKR Pico, or other controllers and peripherals using the standardized EMS clips.

Features

• Precision Fit: Sized exactly for the 180mm variant of the Salad Fork.

• Modular: Uses the FT EMS standard, meaning any compatible clips from the original project or the community will snap right in.

• Lightweight: The "Skeleton" design minimizes filament usage while maintaining structural rigidity for your electronics.

Credits

This model is a remix of FT EMS Frames by Fizzy. All credit for the mounting system logic and original frame design goes to them.

Print Settings

• Material: ABS or ASA (Recommended due to the heat in the electronics compartment).

• Wall Count: 4

• Top/Bottom Layers: 5

• Infill: 40% (Gyroid or Cubic)

• Supports: None required.

Installation

Simply mount the grid to your Salad Fork's bottom extrusions using standard M3 hardware and M3 hex nuts, then use EMS clips to secure your boards and cable management.