I leaned over the table in my camper and broke the plastic foot securing it in place. I printed this at 50% fill out of ABS and it appears much stronger than the one it replaced.
Update: It is now a year later, I leaned on the table again and this time the other original foot broke. I printed a 2nd foot (the two tone in the second pic) I printed this one in ASA and ran out of green, so I switched to white. I printed this one at 103% size for a better fit than the 1st one. it worked perfect (104% would have required no force to insert) So far the two original "feet" on the table side of the legs are holding up fine so they have not been replaced. I used .2 layers this time for a faster print, it is fine.