Summary

This is a mount for a BeaglePrint for an Anycubic I3 Mega. I did not want to install it on a tripod etc. since I don't have much space around my printer.

Additional hardware required (two of each item):
-Normal wood screw, length ~30 mm, might need to be trimmed
-M3x30mm bolt
-M3 nut and washer

The hole in the main body can be used to fix the USB cables with a zip tie to the assembly.
Press the nuts into the holder and slide it behind the stamped holes in the left side of the gantry, with the nuts facing away from you.

I also included a longer main body, which has some cut-outs to save material and time.

The holder has two main problems:
1) The image is 90° tilted
2) The focal distance to the printbed is less than the recommended 20cm.