Just purchased this awesome flat design water bottle to fit into my work bag and immediately started working on a low profile vertical stand I could use to hold it upright on my desk.

I printed it on my Creality Ender 5 Pro using 3D Fillies PLA+ and it has come out with a good, easy fit. Slides right on and off without friction but still holds tight when attached. Fit is snug enough to lift up the stand with the bottle when taken off the desk.

Memobottle have a few different sizes so if you're interested in a bottle you can find them at www.memobottle.com.au

Print Settings

• No Supports
• 20% Infill