Smaller remix from Webcam cover by mitpro: https://www.thingiverse.com/thing:2754874

I decided to remix it 'cause I needed a smaller one, without extended bands at the sides.

Easy to print, no supports neither raft but 100% infill to make it solid due it's very small.

It's perfect for my Asus F541U, only in case you were wondering why I needed smaller. My computer has two microphones (stereo) at the sides of the webcam, so the original one was too large, and it was covering the webcam. Besides both microphones!

Attention! It is difficult to print it, use slow speed and retraction. Find the best settings for small prints for your printer ;)

Print Settings

Printer:

Hephestos Prusa i3

Rafts: 

No

Supports:

No

Resolution: 

smaller than 0.1 mm

Infill:

100%