Just a simple kitchen sponge holder designed to clip on to generic chinese wall soap dispenser sold by Leroy Merlin in Russia. It may, however, fit other chinese soap dispensers which look alike.

Should accomodate for sponges up to 60x90 mm.

If you are unsure whether this holder fits your dispenser or not, print and try to clip on probe.stl before printing full holder.

Holder prevents soap/detergent from accidentally dripping on the table and allows to pour onto sponge whether it is in place or under the holder (cutout is coaxial with dispenser's outlet).

In case you need be extra sure nothing is dripping, use removable dummy (sponge_dummy.stl) to close main cutout.

Tronxy P802MA

Doesn't Matter

Yes

0.2 mm

10%

I printed in PLA, other filaments should be OK too.

Loosen lower dispenser screw a bit, insert sponge holder to full stop, tighten screw again.