This is a relatively simple mount for a ZimaBlade, its designed for the blade to be slid on the holder and be bolted to the back of a monitor, this may be used where the ZimaBlade is used as a media player, or digital signage.

The PCIe can be accessed as its designed to have the PCIe to the top however in most use cases as a media player or digital signage this would not be used, with typically only the power in and video out being used.  It would be possible to use USBC for both power and video as long as the USB C host can output the correct power levels.

The case has mouldings for cable management , with a bolt or cable tie being used to capture the cables, and the hex holes  are both the reduce filament use but also encourage a little airflow to allow passive cooling when in use. 

For printing ensure supports are in place for the hole area.

Post printing a little smoothing / clean up with sandpaper is needed to remove all the supports and any raft/brim needed to put the supports in  place.