Purpose

Designed to securely hold square coasters, this holder keeps them organized and accessible. 

It can holdup to six coasters 95mm square x 3mm thick. I will use it to with the wood coaster that I make.

Printing Suggestions

• Recommend using PLA or a wood-fill filament for texture enhancement. I used Creality PLA wood light pine.
• Print with a layer height of 0.16 mm for a balance between quality and speed.
• Consider using a brim and glue to prevent warping of the base during the print.

Assembly Instructions

The holder prints in one piece requires no assembly. 

The last photograph is a sample of Creality PLA wood half of which I stained to match the wood of the coasters but as expected not succesful as the stain only slightly darkened the wood PLA.