Bracelet Bending Block
Ollanuna07
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
1
0
게시일:2026-04-05 18:25:08
0
0
010설명
모델 소스
리뷰(0)
This is a bracelet bending block to bend flat strips of metal into cuff-style bracelets. The larger circles are for a wider, bend in the middle and the smaller circles are to introduce the bends on the ends to wrap around the wrist.
I made this block the same dimensions as a few you can find on Amazon. Obviously it's quite large. For the project I just did the band was only ½" wide so I made a much smaller one to save on printing time. If you're doing a small bracelet as opposed to a wide cuff you might want to make all items a bit shorter to avoid printing the whole thing.
You can find videos of this process on YouTube.
Print Settings
Printer Brand:
Monoprice
Printer:
Maker Select Plus
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
Gradual Grid
Filament: Monoprice PLA White
Notes:
Filament type probably isn't important as it only needs to withstand loads from the walls, which are designed purposefully thick.
Sanding/Smoothing
It might be necessary to sand or otherwise smooth the surface of the dies. Softer metals might pick up an imprint of the layer lines if they're pronounced.
모델 소스
원본 링크: 자세히 보기
CC-BY