This clip will lock-on your hot-end cable harness by using the screws that hold the HE280 accelerometer board down.

Not a true remix, but the original inspired me. I don't have the whole HE280, I have the accelerometer board and an E3D V6, so I don't have the mounting points for the cover. Had to design this up using the STEP file from SeeMeCNC of the board itself for dimensions and fine-tuned it in Fusion 360. First version was too tight.

It collides with a few small components on the board, but it doesn't appear to be an issue yet. Might resolve in a later version.

Fusion exported as thousandths of an inch I think - requires scaling by 2540x for proper size.