This model represents a fusion of nature's raw power and modern computational design. The transition from a solid, detailed head to a cellular-structured base makes it an ideal technical display piece to demonstrate the precision of a 3D printer.

Key Features

* **Structural Style:** Hybrid design utilizing **Voronoi tessellation** on the legs and base, allowing the sculpture to be seen through.

* **Surface Complexity:** Highly detailed mane with overlapping strands that create deep shadows.

* **Self-Supporting Base:** The net structure at the base acts as its own pedestal, distributing the weight evenly.

* **Geometric Challenge:** Features multiple bridging and angled sections in the chest area and openwork legs.

Suggested Printing Guide

For best results, I recommend the following settings depending on your printing technology:

1. General Recommendations

* **Ideal Material:** * **Resin (SLA):** Ideal for capturing the detail of the mouth and eyes.

* **PLA (FDM):** Matte white or "Marble" for a marbled sculpture finish.

* **Scale:** It is recommended to print at a minimum size of **15 cm in height** to prevent the walls of the openwork structure from becoming too fragile.

2. FDM (Filament) Settings

| Parameter | Suggested Value |

| **Layer Height** | 0.12mm to 0.16mm (to smooth the curves of the mane) |

| **Infill** | 10-15% (Gyroid is preferable for its multidirectional strength) |

| **Supports** | **Yes, Tree Supports.** Focus them only on the lower jaw and the raised leg. |

**Speed** | 40-50 mm/s (reduce in the area of ​​the openwork base) |

**Retraction** | Optimized settings to avoid stringing between the gaps. |

3. SLA Setup (Resin)

* **Orientation:** Tilt the model back about **30-45 degrees**. This helps position the supports mostly at the back and avoids damaging the facial detail.

* **Hollowing:** If it's a large piece, it's advisable to hollow it out with **2mm** walls to save resin, ensuring drainage holes in the hidden areas of the base.

Post-Processing Tips

1. **Cleaning Supports:** Take extra care when removing supports from the mane and tusk area, as these are the most fragile parts.

2. **Finishing:** Lightly sanding the layer lines on the back and applying a matte varnish will give it a **porcelain or carved stone** appearance.