The model was printed using PLA filament
I created a paint shaker for the Elegoo Mercury Plus workstation, which can be used with Valejo, Army Paints, and other brands of the same size.
Perhaps it can also be used in other cleaning stations, but I'm not sure about the spacing between the magnets. The assembly requires a 608 bearing and two 14x5mm magnets. The size of other magnets can be adjusted in the slicing software, but I recommend using strong magnets.
The bearing is glued together with strong adhesive and magnets to form the base of the rocking cradle. On the other side, four cups are glued to the bottle.
The supporting part is attached to the base with spikes. It is used to define the gap between the cleaning station and the shaking bed.
Finally, the base with spikes and the cradle part of the base are connected together by a central pin.