I made this model real quick to help with pouring silica beads back into their container after I finish drying them on the oven. I wanted the wide end of the funnel to be as large as the P2S can make it so I don't have to worry about spilling, and the small end fits easily and sturdily into the mouth of the container. It prints in vase mode to be as fast as possible; though, I did have to limit the speed to make sure PLA cools down enough before the next layer comes down. Profiles are included for 0.8, 0.6, and 0.4 nozzles. I recommend using the largest nozzle you have both for speed and extra strength from the larger layers.

Print Times

0.8 Nozzle - 1 hour

0.6 Nozzle - 1 hour 10 minutes

0.4 Nozzle - 1 hour 45 minutes