This is a mobil phone case there can be adjusted to the most mobile phones. You can have plastic film in front or don't. I use it at fitness and at work, when I am places where I can't hear my phone in the pockets.

In openscad you can fill in your phones measurement at create single parts by unselecting the other parts and the do a rendering please remember to give each STL a unik name so your not overwriting them when saving them.

I have used 3mm screw, and 3mm nail for press lock if the screw never has to be taken out..

PhoneWide : the wide of the phone
PhoneHeight : the height
PhoneThickness : the thickness of the phone

LeftScrewOffset : Center screw at front can be moved
RightScrewOffset : Same but Right side

LeftLockOffset : Again it can be moved to a bette place
RightLockOffset : Same but right side

ShowBase : For better view and rendering of the single part
ShowBack : for better view and rendering of the single part
ShowFront : for better view and rendering of the single part

Front_add_buttom : add frame wide in the buttom
Front_add_top : add frame wide for the top
Front_add_sides : add frame wide for the sides

FrontIButton_ena : will make a hole for button. (don't think it works well)
FrontIBotton_Offset : move it up and down

ShowLock : for better view and rendering of the single part

ShowButton_1 : for better view and rendering of the single part
Button_1_Enable : make hole in Base and create button
Button_1_Right : make it to the right side else left
Button_1_Offset : Move from y zero
Button_1_screw_front : Let the screw has hole to the front

Charger_Enabled : make Hole for charger (would not use it)
Charger_Wdt : The width of the hole
Charger_Height : The Height of the hole

ShowBackCam1 : Make hole for camera
Cam1_offsetX : X offset from x=0
Cam1_OffsetY : Y offset form y=0

ShowBackCam2 : Same as Cam1 but a new hole
..
..

LinkBackCams : The 2 holes can be linked to a oval shape.

Doesn't Matter

Doesn't Matter

I have used PLA and some PETG.