I didn't like the way my filament was angled going into the extruder, so I set out to find a guide. Then I found the original...

I made the wheel wider so i can run different spools from different angles without having to relocate them all the time.

I remodelled the screw area so that you don't have to completely remove the screws from the printer to install this. I had a heck of a time getting those two flip'n screws back in after installing the original.

I added a swivel guide (print in place) that can slide side to side. Might be useful to some and not to others. But it can be removed if you don't like the feature so it's all good.

Aquila C2

Yes

Yes