Tablet holder made using aluminum rods, in order to increase resistance and give a nice look.

See the "Post-Printing" section to know the correct sizes for the rods.

I put only the "Right_Hook" in the files, just mirror it in the slicer to get also the left one.

Flyingbear Ghost 5

No

Yes

0.2

10%

Use supports only for the "T_Join"

The correct sizes for the rods are

d1: 16mm x l1: 137mm (the large one)
d2: 10mm x l2: 210mm (the small one)

However you are free to choose the length you want, based on you necessities.
Keep in mind that the 16mm one should be long at least 57,2mm, and the 10mm one should be long at least 100mm
(NOTE: if you use the minimum lengths the rods will not be visibile)

In case the hooks became too soft in future, I added an hole where you can put a small screw in order to tighten it up.