Wheel adapter to use your EGO String Trimmer as a sidewalk edger.

Fits my EGO string trimmer with the aluminum shaft (mine is Model ST-1510T but might fit others).

This is a remix of another one here that didn't fit my string trimmer. That one required a spare scooter wheel to be used, as well as didn't fit my trimmer, so I made this one instead. It uses two common 608 bearings and the wheel is printed of TPU.

Instructions:

• PETG recommended, except for wheel which is TPU
• Recommend higher number of outer shells and higher infill for strength.
• For the TPU I believe I used around 6 inner/outer shells and 40% gyroid infill
• No supports needed
• Print @2 inner spacers and @2 outer spacers. See cross-section image for where spacers go (bearings not pictured)

Will need:

• 2@ M4 x 25mm bolts, plus washers and nuts
• 3@ M4 x 50mm bolts, plus washers and nuts (no washers in top side of hole)
• 1@ M8 x 80mm bolt for the bearings/wheel, plus washers and nut
  I recommend blue loc-tite (removable kind) on all bolts