Quick and dirty, just to have this for traveling with the Oculus Go. Not optimised yet (as you can see from the huge patch of support-material that has been removed from underneath. I used some 25mm (thats one inch) wide hook-and-loop straps, but you can probably use any sort of strap thats less than 4mm (about 1/6", thinner is better) thick and less than 30mm (1-1/6") wide. Thanks to the foam it stays in by itself, but I don't feel like risking it. Don't know if it'll fit with prescription lenses fitted.

Use at your own risk, as usual!

MakerBot

MakerBot Replicator 2

Yes

Yes

0.2mm

8%

I used 2 shells. This doesn't need too much when it comes to printing. Just use support and place it "legs down" and you should be fine.