Knocking the screen on the Bitaxe is inevitable if you're playing around or modifying it.
Eventually, you end up knocking the soldering loose, breaking the screen, or just loosening it enough to disconnect the screen.

This model should prevent the above.
Very quick print (<8min).
Should support the screen from bending and bumping.

Designed based on the original by @TheSoloMiningCo.
I found the other model to be too tall for the Bitaxe (tall enough that the connector pins no longer touched the board), so here's the remixed version.

Creality

Ender-3 V3 SE

No

No

10%

Doesn't need supports, but may need brim enabled.
Should only take <8min to print.