Printing Recommendations

• Material: * PEG (Highly recommended)T: Resistant to oils, grease, and higher temperatures found in garages.

  • PLA: Fine for home use, but might warp if left in a hot car or near an engine.

• Infill: 20% (Grid or Gyroid) for better impact resistance.

• Wall Count: 3-4 perimeters to ensure the hinges and latch areas are solid.

• Supports: (Specify here if your design needs them, e.g., "No supports needed" or "Supports required for the latch only").

• Quantity: You must print 2 pieces in total:

  1. 1x Standard orientation.

  2. 1x Mirrored (use the "Mirror" function in your slicer).