Rotating locking mechanism for the second door of the Biohort Europa shed.

Infos

• simple design - only two printing parts
• 90° angle of rotation
• seamless design, no visible fasteners or screws
• easy adhesive mounting to the inside wall of the door panel

Assembly

• Use a simple countersunk screw (e.g. M3x25) to connect both printing parts

• 2x aluminum poles, 5-6 mm diameter, approx. 1000mm lenght
   
• bending of the poles: bend one end similar to the original door lock. I recommend heating the tip of the rod first and then carefully beginning to bend it
   
• Is there an alternative to bending? Do you have a 3D printer? Congratulations ... You can print a suitable adapter!
   
• Only cut the straight ends of the poles once you have finalized the position of the handle. The length depends on your handle attachment point!
   
• glue the base of the lock with adhesive mounting tape. Insert the rods before final attachment

Print

• use support for the overhanging wings!
• flat wings are important to ensure good rotation of the bended rod hooks 
• use ASA or other heat resistant printing material - the shed can get hot in summer time!