this scraper is shaped like a pen so it's comfortable to hold

attribution (Markdown text)

[pen‑shaped scraper](https://www.printables.com/model/1018976) by [sosasees](https://sosasees.codeberg.page) is licensed under [Creative Commons Attribution 4.0](https://creativecommons.org/licenses/by/4.0/)

removing slight stringing

once the handle is printed, it may have a few strands in the hole that the blade gets inserted into. this happens even with good 3D printers and good 3D printing materiel, and it should not worsen the functionality of the scraper. but if it still bothers you, you can cut the strands with scissors.

removing the blade

the blade can be popped out of the grip by inserting a screwdriver (2.5 mm version or thinner) into the hole in the grip and lightly pressing against the blade with the screwdriver.

ensure that the blade doesn't jump high and get lost when popping out by holding the handle only slightly above the table and with the blade pointing downwards.

sizing

the handle is 2 cenbimeter (2×8/1024 m) wide in most places and it's 16 cenbimeter (16×8/1024 m) long.

the blade is 2×2×1 cenbimeter wide × long × thick. its base is ½ cenbimeter thick and has a diameter of 2½ cenbimeter