Simple case for Motorola E7 Plus made to be printed in TPU filament.

Filament : TPU (Mandatory!!!)

Layer Height : 0.1mm 

Can be anywhere from 0.5 to 0.25 depending on your printer, filament, and other variables.

Speed : 30-50 mm/s (recommended)

Infill : 15%

Support : Ideal for quality, but pain to remove with TPU, so if you can do good overhang and bridge with your printer, opt for none, if unsure, enable support.

If you want a pattern instead of a flat case, use hexagonal, honeycom, triangular or such infill with the pattern you like and chose 0 top and bottom layers with 4-5 perimeters.

For the pictures, I used 15% 3D hexagonal infill with 0.1mm layer height @50mm/s on a FlashForge Adventurer 5M Pro on stock textured PEI bed with a tad of hairspray. Temp used(for reference only) HotEnd @220C for first layer and @215C for the remaining layers, bed @80C for the whole duration of the print. No support but should have :p

Enjoy !