Replacement shock-absorbing mounts for the comica VM20 microphone.

- Print in PLA or PETG. I used ASA. Use low infill unless you use TPU
- Do not just print one. These are not the same height as the original: you will need 2 to make the microphone straight
- Keep in mind that the screws used on the original metal plate are glued in place. Careful not to strip these screws. I stripped one by accident and had to use pliers to remove it (after cutting off the plastic around the screw).
- You should use new M3 hex-socket bolts to attach these 3d printed mounts to the base plate.

Edit: Use TPU if possible. Rigid materials allow more noise to transfer from the mount and impact audio quality. (This isnt as important if the camera is only on a tripod)