These tools may help with constructing your fingerboard.

• The clamp and sander are for the surface of the fingerboard. The fingerboard often has a radius of 42mm. The sander has the same radius, and is meant to have sandpaper glued to it for surfacing. The clamp has a 43mm radius with the assumption that you will add 1mm of cork to the surface, bringing it to 42mm radius.

• The fingerboard angles tool is for measuring the angle of the fingerboard sides from each end. It will only be correct if your fingerboard has ends of 24mm and 42mm width, and a total length of 270mm.

• The holder will hold the fingerboard while you are working on it.

Verify the radius of the sander before using, as print shrinkage may occur. If needed, scale the print to arrive at the correct radius for your fingerboard.