This is a tablet stand designed to fit into the 19mm (3/4") diameter right-angle clamps on Alesis drum racks or similar sets.

Printing

It's split into two parts for ease of printing, with two connector pieces to ensure perfect alignment. Load the model in the slicer, split it into parts, and it should be obvious how to place each on the bed for perfect printing orientation.

• No supports required.

• Any layer height works, and in fact the higher the better, it would lead to a rough texture on the rod part but that's actually good for the clamp's grip.

• Any rigid material will work. I used PLA.

Assembly

Just put all the parts together and insert into the clamp. Look at the complete model to see how they're supposed to be composed if it isn't clear.

You can glue the connector pieces in place if you want, but it's not really necessarily, since once the clamp is tightened it strongly secures all the parts.

Customizing

The stand fits tablets up to 250mm wide and 9mm thick, but I've also provided a step file and the source fusion file, so changing it should be fairly accessible. It would also be very easy to just remove the side caps so that there's no longer a width limit.

If you've modified it for different dimensions, please add that modification as a remix.