We lost all but one of our old metal stocking holders, and I couldn't find replacements. It was a simple curved design, with a straight bit that holds on top of the mantle.

So I roughly modeled it, modified the dimensions a bit for a sturdier PLA print, and printed off a new set.

This design, at 3mm thick, is sturdy enough for 'decorative' stockings only, at least printed in PLA. There is a little flex in them, which is fine, but if you put giant stockings stuffed full of goodies on one of these... it might not hold up to that!

I printed these in Prusa's green/red Galaxy PLA on my Mk4 and a Bambu Labs P1S.