The plastic wheel on one of my trashcans just seemed to disappear. I had dragged this trash can around on one wheel for months. Now is the time to fix that! Enter, the vernmaDe replacement trashcan wheel!

I used stainless steel screws to secure the two halves and just install right onto the axle. Works GREAT!!! Possibly use an epoxy to keep it together over time, but I didn't just yet. Maybe later but right now I love it.

Fix your cans, don't replace them!

My axle didn't have a nut on the end but a soldered end cap so my wheel had to be in 2 pieces. Possibly mesh the two pieces if you have an open end axle. Then just print, post process, ream out and install.

Doesn't Matter

Yes

.35

50%

High infill for extra strength. I think I used 3 walls as well. You may have to reem the center hole out for your specific axle.