• Filament Type: PLA

• Infill: 15%

• Layer Height: 0.16 mm

• Supports: Everywhere

Components used:

• ProMicro NRF52840 Development Board (Nice!Nano V2.0 compatible)

• SX1262 module

• FAKETEC PCB

• SMA to IPEX (IPX) pigtail cable 

• GIZONT antenna

• Flat LiPo battery  803048

• 3-4 screws (used whatever was available)

Assembly:

• Connect the ProMicro board to the FAKETEC PCB using pin headers (PLS), then trim the pins after soldering.

Notes:

• I used a 4 cm pigtail, but space is very limited.

• There may be issues with the panels, as they fit onto the frame worse than in the original larger model.

Future improvements:

• Once the power switch and BMS protection arrive, I will try to integrate them into the model.