100mm powder basket
Hole is 10.5mm at the top, tapered 1 degree

11/06/15 NOTE: If you printed one of the .mfp files before this note, there has been a minor change that greatly increases the stiffness of the part, and only add .1CC of Kevlar to the print

If you are printing on a Markforged Mark One, I highly recommend you download one of the included .mpf files and print from a USB. I put a lot of work into the fiber layout and you won't get that with just the .stl.

Revisions:
Rev C features larger (cooler looking) slots and the REV B updates
Rev B has been updated with a larger (1.125mm) bottom edge fillet that markforged will not remove with "thin features" turned off and better surfacing on the cutaway at the back

In the .mfps, each basket uses 17.3cc nylon (REV C) or 18.4cc nylon (REV B) and 2.4cc kevlar (both revs).

The picture of the rev B is an old fiber layout.

No

Yes