So I like my podcasts.   Could buy a speaker.  Or I could print something.  Some other phone holders are kinda like a pocket.  I don't like listening to the same commercial time and time again (especially because I binge)… so … this!

The phone is held flat near the top of the door — your choice inside or outside.  You can reach up, shake the water off your hand and hit skip when needed.

Print is in 3 parts: the base and two copies of the hooks.  The base (v3) has cuts into it's sides to make it easier to grasp the phone when you're done.

I've included the v1-2-3 progression… with OpenSCAD source.  Two m5 bolts (and nuts with capture) are used to put together the pieces.