This is my first attempt at using the built-in 3D Builder tool in Windows and not using any 3d modeling software to post process the resulting STL file.

Mount is improved for the following:

1. Lowered the BLTouch mount by 5.70mm as the original is way above the hot end even with the probe extended
2. Cut the wire support coz as I find it too high, stressing the wires when the printhead is at the rightmost end of the X-carriage
3. Cut the lower back of the mount to allow more clearance for the V6 radiator for easier insertion with the heater cartridge attached
4. Mount face has been remixed to add a mount for a surface-mounted LED
5. Added a 40mm fan cover as I always accidentally hit the fan. The cover fits a Noctua NF-A4-20

Also included is a wire chain connector suitable for this wire chain:
https://www.thingiverse.com/thing:3769941

Use a zip tie to fasten the wire chain connector.

Creality

Ender 3

No

No

200

38