Liked very much the cute mini octopus.
https://www.thingiverse.com/thing:3495390

For sure I cant stop playing with them!
So I decided to design a spinning top with the tentacles.

This is a 2 piece spinning toy!
You can watch it how it spins in youtube:

https://youtu.be/VwixWWzg6jI

Brim is required. I used 10 mmm only for the octopus. skirt for the spinning base is ok.

It takes About 3 hours for the octopus and 15 minutes for the spinning base.

Please rotate necessarily.
the spinning base must be printed so the tip is on top.
The octopus must be printed with the hole at the bottom
No supports required.
Please don't scale down! The tentacles will not work. only scaling up if you want it.

Enjoy!

Creality

Ender 3

No

No

0.2

20%