Replacement part for when the clip on swim goggles breaks. Modeled after Speedo's design, it works well with the 5mm wide silicone strap that is common to most goggles.

7/28/19 - Added the SolidWorks part file

This clip was designed in SolidWorks using basic sketch and extrude functions. Dimensions were directly measured from my Speedo Vanquisher goggles. This is a piece that, for me, often breaks before the goggles wear out or straps break. I used 100% infill on the print and designed the clip with additional load bearing geometry to maximize strength. In the photos, the clear clip is a manufacture original, while the red clip is my design.