Simple, blocky hardware for your 24 V power supply. Secures the PSU vertically to the side of the frame with short M3 screws and no t-slot nuts.

Hardware needed:
3 M3x10mm screws

Print one copy of psu_top and two copies of psu_bottom. Drill out the support layer in the screw holes.

Place the bottom mounts between the two extrusions of the frame base and secure to the PSU with M3x10mm screws.

Insert the hook of the upper mount into the inside slot of the diagonal extrusion above the lower mounts. Fasten it to the PSU with an M3x10mm screw.