Clip to attach the lid/cap of the 8BitDo USB Wireless Adapter 2 (not tested with 1) when plugged in to the body so you dont lose it. Button and LED are still visible and accessable when the lid is off.

It's friction fit and the cap uses the same small clip as the USB end. Tolerences are tight to my own Bambu A1 and Matte PLA so your printer may vary.

I recommend printing a -0.5% and +0.5% scale one in one go and printing temp on the higher end for better layer adhesion on the smaller clip. I used 0.08mm layer height on a 0.4mm nozzle. Snug supports for overhang.