created a stem that a BIC Pen insert could be sliped into so you can write with the flower and refill as needed.

The petals and center can be found on the original posting

www.thingiverse.com/thing:2182466

A little support is needed under the ends that insert into the flower petals.

May need to sink it a little under the plate if you do not have good adhesion

I used a heat gun to bend the end so the flower was facing forward not upwards and shape the leaves after it was assembled.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Category: Decor